Holdover Time, Explained: A Winter De-Icing Refresher for Business Jet Crews
The FAA's 2026–2027 holdover time guidelines are out. What the clean-aircraft rule, fluid types and the HOT clock mean for business jet crews this winter.

The first frosty mornings are here, and with them the annual ritual on the ramp: the de-ice truck, the orange or green spray, and a clock that starts running the moment fluid hits the airplane.
The FAA published its Holdover Time Guidelines for Winter 2026–2027 on Aug. 11. Here is a plain-language refresher on what those tables do, and what they don't.
The rule behind it all: a clean wing
For large and turbine-powered multiengine airplanes flown under Part 91, 14 CFR 91.527 is blunt: no pilot may take off with frost, ice or snow adhering to the wings, control surfaces, windshield, engines or key flight instrument systems. The one exception is frost under the wing in the fuel tank area, and only if the FAA has authorized it.
Charter crews have an extra layer. Under 14 CFR 135.227, when frost, ice or snow may reasonably be expected to stick to the airplane, the pilot must have completed the operator's ground icing training and meet one of three options: an approved pretakeoff contamination check within five minutes before starting the takeoff, an approved alternative procedure, or an approved deicing/anti-icing program that follows the airline rule in § 121.629(c).
De-icing and anti-icing are two different jobs
De-icing removes what's already on the airplane. Anti-icing protects the clean surface for a limited time. The FAA's General Information document notes that holdover times apply to anti-icing, not de-icing.
The fluids behave differently:
- Type I is a thin, glycol-based fluid, orange when dyed, used mainly for de-icing. It dilutes quickly in precipitation, and its holdover times are "considerably less" than the thicker fluids', according to the FAA. To use the Type I tables, it must be applied heated, at least 60 °C (140 °F) at the nozzle, and at about 2 gallons per 100 square feet. Composite surfaces get shorter Type I times because they hold less heat.
- Types II, III and IV contain thickeners. They cling to the wing while you wait, then thin out during the takeoff roll so the fluid flows off before liftoff. Their holdover times depend on outside air temperature, the type and intensity of precipitation, and the fluid concentration. A "75/25" mix is 75 percent fluid and 25 percent water.
The FAA also sets freezing-point buffers: Type I must stay at least 10 °C (18 °F) below the outside air temperature, and Types II, III and IV at least 7 °C (13 °F) below.
When the clock starts, and why it never pauses
In a one-step application, the holdover clock starts when fluid application begins. In a two-step application, it starts at the beginning of the final anti-icing step. Once started, the FAA says, the clock should not be stopped just because the snow lets up. Precipitation keeps diluting the fluid and gravity keeps draining it, and there is no practical way to know how much protection is left.
If the precipitation turns heavier than the rate your time was based on, the FAA says a revised, shorter holdover time applies. If that time has already passed, the options are a pretakeoff contamination check or going back for another treatment.
What a failing fluid looks like
The holdover tables don't cover heavy snow. For those conditions, the FAA describes the warning signs: the fluid turns less glossy and more opaque, and snow starts building up on it. At that point the fluid has failed and takeoff is not authorized. If you check from inside the airplane, the view must not be blocked by fluid, dirt or fogging. If you can't see the surfaces clearly, the check should be done from outside.
Use this season's tables
The FAA publishes new tables every season and can update them mid-winter; each new version makes the old one obsolete. The inspector guidance that goes with them, Notice 8900.784, was issued Aug. 3 and replaces last winter's notice. Check the FAA's ground deicing page before the season and again during it. Your operator's approved program and your airplane flight manual always come first.
Sources
- FAA: Holdover Time Guidelines, Winter 2026–2027 (Original Issue, Aug. 11, 2026)
- FAA: Ground Deicing Program General Information, Winter 2026–2027
- FAA Notice 8900.784: FAA's Deicing Program for Winter 2026–2027
- eCFR: 14 CFR 91.527, Operating in icing conditions
- eCFR: 14 CFR 135.227, Icing conditions: Operating limitations
- FAA: Aircraft Ground Deicing