Living Between FL290 and FL410: An RVSM Refresher for Part 91 Business Jet Operators and Crews
What 14 CFR 91.180 and Part 91 Appendix G require for RVSM: ADS-B and LOA paths, flight plan filing, altimeter checks and contingency procedures.
Between flight level 290 and FL410, the airspace most business jets call home, air traffic control separates aircraft by just 1,000 feet vertically. That is half the 2,000 feet that applied above FL290 before reduced vertical separation minimum, or RVSM, was introduced.
The FAA says RVSM saves fuel and adds airspace capacity. The price is that the airplane, the operator and the pilots all have to meet a standard first.
This explainer walks through what the rules say for Part 91 operators and what crews are expected to do on the flight deck. It is based on 14 CFR 91.180, Part 91 Appendix G, the FAA's Advisory Circular 91-85B and Chapter 4, Section 6 of the Aeronautical Information Manual. Your aircraft flight manual and operator procedures come first.
The rule in one sentence
Section 91.180 says no one may operate a civil aircraft in RVSM airspace unless the operator and the aircraft meet the standards of Appendix G and the operator is authorized by the FAA or the country of registry. The FAA may authorize deviations.
Two paths to authorization
The ADS-B path (Appendix G, Section 9). Since a 2016 rule change, an operator is authorized to fly in RVSM airspace without applying for a letter, provided the aircraft carries the required equipment, its altimetry system error stays within 200 feet, and it has ADS-B Out meeting 14 CFR 91.227. The aircraft's height-keeping must also be monitored in a manner acceptable to the FAA.
AC 91-85B says ADS-B equipped aircraft are height-monitored during normal flights at RVSM altitudes where the FAA has enough ADS-B data. The aircraft's first RVSM flight, whether it is new, freshly altered or returning to RVSM status, must be in that kind of airspace. Its performance must have been monitored and found compliant within the previous 24 months. The FAA tracks aircraft by serial number, so a change of owner or registration does not by itself affect RVSM status under Section 9.
If an aircraft does not meet the monitoring requirements, the AC says the operator must file as non-RVSM until the issue is resolved.
The letter path (Appendix G, Section 3). The AIM is clear on one point that catches some Part 91 crews: Section 9 covers domestic operations. An operator intending to fly RVSM outside U.S. airspace must hold a specific approval, which for Part 91 operators is a letter of authorization. AC 91-85B also points operators to this path if their aircraft do not routinely fly where the FAA can collect ADS-B data, or if a foreign country requires a specific approval.
The equipment
Appendix G lists the same core kit for both paths:
- Two operational, independent altitude measurement systems.
- At least one automatic altitude control system able to hold altitude within plus or minus 65 feet in smooth, level flight. Aircraft whose type certification was applied for on or before April 9, 1997, and that use flight management inputs may meet a 130-foot band instead.
- An altitude alerter that triggers at 300 feet from the selected altitude for aircraft in that older group, or 200 feet for newer designs.
- If TCAS II is installed, it must meet TSO-C119b (Version 7.0) or later, unless the FAA authorizes otherwise.
Filing the flight plan
Appendix G requires the flight plan to show the operator's and aircraft's RVSM status correctly. Under the AIM, that means filing "W" in the equipment field only after confirming both are approved. An operator flying under Section 9 domestically may file "W." An operator without a letter should not file "W" for RVSM outside the United States.
For a non-RVSM flight, the AIM says the "W" must actually be removed. Writing "NON-RVSM" in the remarks while leaving the "W" in place does not give controllers the cue they need.
On the ground and in the climb
AC 91-85B's operating practices start before engine start:
- Check the maintenance records for the condition of RVSM equipment.
- On the walkaround, look closely at the static ports and the skin around them.
- Before takeoff, with the local altimeter setting, the altimeters should show a known elevation within flight manual limits, and the difference should not exceed 75 feet. The two primary altimeters should also agree within flight manual limits.
If any required equipment fails before entering RVSM airspace, the AC says the pilot should request a new clearance to avoid it.
In the climb, the AC emphasizes setting 29.92 promptly on all altimeters at the transition altitude and rechecking at the first cleared level. Level-offs should not overshoot or undershoot by more than 150 feet.
In cruise
At cruise, the autopilot's altitude hold should be engaged except when retrimming or turbulence requires otherwise. The two primary altimeters should agree within 200 feet, or less if the flight manual says so, and the crew should note the difference from the standby. Cross-checks between primary and standby altimeters are recommended about once an hour. Over the ocean, the AC says the crew should record a cross-check near coast-out.
If ATC reports an assigned altitude deviation of 300 feet or more, the pilot should return to the cleared level as quickly as possible. Appendix G separately requires operators to report altitude-keeping errors to the FAA, including a total vertical error or assigned altitude deviation of 300 feet or more.
When things go wrong
The AIM gives crews specific phraseology:
- "Unable RVSM due equipment" if the autopilot altitude hold, the altitude alerter or all primary altimeters fail. Request a clearance out of RVSM airspace unless the situation dictates otherwise. Controllers will then provide 2,000 feet of vertical separation or lateral spacing.
- "Unable RVSM due turbulence" or "due mountain wave" when weather causes altitude deviations of about 200 feet. Ask for a vector away from traffic at adjacent levels if ATC has not already offered one.
- "Ready to resume RVSM" once the problem is behind you.
In any of these cases, the AIM's first steps are the same: tell ATC, hold the cleared level as well as possible, watch for traffic visually and on TCAS, and consider turning on exterior lights.
Sources
- 14 CFR 91.180, Operations within airspace designated as RVSM airspace (eCFR)
- 14 CFR Part 91, Appendix G, Operations in RVSM Airspace (eCFR)
- FAA Advisory Circular 91-85B, Authorization of Aircraft and Operators for Flight in RVSM Airspace (status page)
- FAA AC 91-85B (PDF)
- FAA Aeronautical Information Manual, Chapter 4, Section 6: RVSM operational policy and procedures
- FAA: Reduced Vertical Separation Minimum (RVSM)